Coolant and particulate tray (suits bandsaw MBS 240/E)
This Relativity™ Australian-made product 44053 replaces the Proxxon German-made product 28189 which was discontinued in 2012/2013. Durable coated steel tray with drain nipple fitted, dual stainless steel RHS legs drilled for bench mounting. Useful when water cooling is used during sawing of metals and plastics. Also used by jewellers to collect the lemel of precious metals during wet or dry sawing. Radiused corners assist 100% lemel recovery.
The 27172 Bandsaw (not included) is supported clear of any collected water and particulates, on four pedestals, o-ring sealed to the tray.
We include a pair of M8 nipples to insert in the existing drain holes in the bandsaw table.
We include a length of 10mm ID flexible plastic tubing and a 90-degree drain elbow, to allow routing of the drain from the tray's drain nipple to a below-bench waste bin (not supplied).
The stainless steel RHS legs allow the bandsaw often to be used without attaching it to the bench, but offer four counterbored holes for bench attachment if preferred. Unlike the discontinued German product, you may now move the machine without breaking the water-seal.
The four support pedestals with o-ring seals include stainless steel screws and nuts.
Pre-drilled tray with 10mm drain nipple fitted
Plastic flexible tubing
90-degree 10mm drain elbow
Four pedestals with o-ring seals, stainless screws and nuts
Two stainless steel RHS legs with end caps
17mm pedestal height elevates bandsaw above the waste
10mm drain system
Stainless steel 304 screws, nuts and legs
We include 4 pedestals, tray nipple, 10mm drain tubing & elbow (not shown), 2 table nipples, 2 legs
Be The First To Review This Product!
Help other Hobby Tools Australia users shop smarter by writing reviews for products you have purchased.